Metric And SAE, In The Same Drawer

Two systems in one box is how tools go missing. Label the slots, stand everything on end, and the drawer tells you what is gone.

  • Size labels in metric and SAE
  • Snaps together - modular system
  • 60-day money-back guarantee
Where do I start?
Person working on a car with tools and a green Grypmat tool organizer in a garage setting.

Three ways to stop mixing them up.

Pick the drawer where metric and SAE are costing you the most time.

Plier vertical wrench organizers Start here

Label the wrenches

Pick this if:You pick up three wrenches before you get the right one

Vertical holders stand every wrench on end, and the metric or SAE label inserts put the size where you can read it.

Shop wrench organizers
3/8" Socket Organizers - Toolbox Widget USA Socket Organizer, Socket Organization, Toolbox Widget, Tool Box Widget, Tool Organization, Socket Holder, Socket Tray

Stem the sockets

Pick this if:Your metric and SAE sockets share a drawer

Drive-specific holders plus size stems in both standards, so a socket in the wrong slot is obvious before the drawer closes.

Shop socket organizers
Grypmat Plus Trio flexible tool tray mat set close-up view 2

A surface at the car

Pick this if:You are setting tools on a fender, a bumper or the engine cover

Grypmat grips on an angle so nothing slides off a sloped panel, and it will not scratch paint. Roll it up and it moves to the next bay with you.

Shop tool mats
Skip to results list

How it compares to what's in your drawer now

Toolbox Widget Plastic trays 3D-printed trays
Setup Drop in. Magnet locks it down. Drops in, then slides around A few per print run, then sanding and test fits
New tool? Snap on a holder Buy another tray and hope the size exists Model it, print it, wait
Tools stay put Grip + magnet. Slam it. Rattle, tip, and slide Loose fit unless printed dead-on
Spot a missing tool Empty slot, at a glance A loose pile tells you nothing Only if slots are labeled
Upfront cost More than a tray or a print Cheapest option Printer, filament, and print hours

Shop by Specialty